- Epoxy paint 2 part Patch#
- Epoxy paint 2 part free#
To test for moisture, cut a piece of thick black plastic into 1m². If this is not available, proceed using the method below. Ideally use a concrete moisture meter to determine the moisture content. Epoxy paint 2 part free#
The substrate must be dry and free from any rising moisture. Alternatively, prime with Aqua Prime on a highly porous surfaces. Generally only two coats are required, however on a highly porous surface then a third coat may be necessary. Always follow the manufacturer’s guidelines for coverage. The substrate must be cool to touch before applying any sealer or coating. Do not apply when the ambient temperature is below 15c or above 28c. Epoxy is not designed to be applied to outdoor substrates. Epoxy paint 2 part Patch#
It is recommended to do a test patch first to determine the suitability of the product. Ensure to read the TECHNICAL DATA SHEET, the PREPARATION GUIDE and the APPLICATION INSTRUCTIONS thoroughly first. If longer than 90 seconds, then it may be necessary to either acid wash or diamond grind the concrete to open it up and create the required porosity. 
If under 90 seconds then the concrete has sufficient porosity for application of the sealer.Repeat the test over multiple sections of the concrete substrate.For sufficient porosity to apply a sealer, this should be no longer than 90 seconds.
Time the amount of time it takes for the water to soak into the concrete. Dip a finger into a glass of water and apply 2-3 drops to the surface. Ensure the concrete has sufficient porosity for the sealer to penetrate. The easier and quicker that water soaks in, the more porous the concrete is and the more product you will use. If using for a flake flooring system, only 1 coat is necessary.Ĭoverage rates will be determined by how porous the concrete is (how easily water soaks in). Once the product has been applied, Right Choice can take no responsibility for any discrepancies in colour variations.ġ0 litres will do 2 coats over approximately 25m² – 30m² (concrete porosity dependent). Please ensure to check the colour of the sealer prior to installation. * If using for a flake flooring system, only 1 coat is necessary. Please note: If the concrete is highly porous, it is recommended to prime the substrate prior to the application of the Water Based Epoxy with the Right Choice Aqua Prime 1L Penetrating Concentrate. Right Choice epoxy is used as the base coat in the Epoxy Flake Flooring system. Water Based Epoxy also performs exceptionally well on surfaces exposed to aggressive environments such as factory floors, tank linings, wet areas and food processing plants. The kit is available in a variety of colours and especially suitable for damp surfaces while dramatically improving the ease of maintenance and cleaning of the coated surface. Water Based Epoxy should be considered for all interior concrete sealing applications where superior durability is required and solvent odors and flammability are not acceptable. It resists stains, abrasions and chemicals such as oils and grease etc. The kit includes a Part A resin and a Part B hardener, to create an exceptional showroom quality finish. 
Water Based Epoxy is a high performance, commercial grade, 3:1 epoxy coating.
0 kommentar(er)
